READ Free Dumps For Cisco- 200-125
| Question ID 13647 | Which command shows your active Telnet connections?
|
| Option A | show cdp neigbors
|
| Option B | show cdp neigbors
|
| Option C | show users
|
| Option D | show vty logins
|
| Correct Answer | B |
Explanation Explanation: The show users shows telnet/ssh connections to your router while show sessions shows telnet/ssh connections from your router (to other devices). The question asks about your active Telnet connections, meaning connections from your router so the answer should be A.
| Question ID 13648 | Which command would you configure globally on a Cisco router that would allow you to
view directly connected Cisco devices?
|
| Option A | enable cdp
|
| Option B | cdp enable
|
| Option C | cdp run
|
| Option D | run cdp
|
| Correct Answer | C |
Explanation Explanation: CDP is enabled on Cisco routers by default. If you prefer not to use the CDP capability, disable it with the no cdp run command. In order to reenable CDP, use the cdp run command in global configuration mode. The cdp enable command is an interface command, not global.