READ Free Dumps For Cisco- 200-125

Question ID 16109	A network administrator needs to allow only one Telnet connection to a router. For anyone viewing the configuration and issuing the show run command, the password for Telnet access should be encrypted. Which set of commands will accomplish this task?
Option A	service password-encryption access-list 1 permit 192.168.1.0 0.0.0.255 line vty 0 4 login password cisco access-class 1
Option B	enable password secret line vty 0 login password cisco
Option C	service password-encryption line vty 1 login password cisco
Option D	service password-encryption line vty 0 4 login password cisco
Correct Answer	C

Explanation Explanation: Only one VTY connection is allowed which is exactly what's requested. Incorrect answer: command. line vty0 4 would enable all 5 vty connections.

Question ID 16110	Which two statements describe the process identifier that is used in the command to configure OSPF on a router? (Choose two.) Router(config)# router ospf 1
Option A	All OSPF routers in an area must have the same process ID.
Option B	Only one process number can be used on the same router.
Option C	Different process identifiers can be used to run multiple OSPF processes
Option D	The process number can be any number from 1 to 65,535.
Option E	Hello packets are sent to each neighbor to determine the processor identifier.
Correct Answer	C,D

Explanation Explanation: Multiple OSPF processes can be configured on a router using multiple process IDs. The valid process IDs are shown below: Edge-B(config)#router ospf ? <1-65535> Process ID

Previous-Page 1 2... 174 175 176 177 178 179 180 181 182 Next-Page

Send email to admin@getfreedumps for new dumps request!!!