AllExam Dumps

DUMPS, FREE DUMPS, VCP5 DUMPS| VMWARE DUMPS, VCP DUMPS, VCP4 DUMPS, VCAP DUMPS, VCDX DUMPS, CISCO DUMPS, CCNA, CCNA DUMPS, CCNP DUMPS, CCIE DUMPS, ITIL, EXIN DUMPS,


READ Free Dumps For Cisco- 200-125





Question ID 13653

Refer to the exhibit.

What commands must be configured on the 2950 switch and the router to allow
communication between host 1 and host 2? (Choose two.)

Option A

Router(config)# interface fastethernet 0/0 Router(config-if)# ip address 192.168.1.1 255.255.255.0 Router(config-if)# no shut down

Option B

Router(config)# interface fastethernet 0/0 Router(config-if)# no shut down Router(config)# interface fastethernet 0/0.1 Router(config-subif)# encapsulation dot1q 10 Router(config-subif)# ip address 192.168.10.1 255.255.255.0 Router(config)# interface fastethernet 0/0.2 Router(config-subif)# encapsulation dot1q 20 Router(config-subif)# ip address 192.168.20.1 255.255.255.0

Option C

Router(config)# router eigrp 100 Router(config-router)# network 192.168.10.0 Router(config-router)# network 192.168.20.0

Option D

Switch1(config)# vlan database Switch1(config-vlan)# vtp domain XYZ Switch1(config-vlan)# vtp server

Option E

Switch1(config)# interface fastethernet 0/1 Switch1(config-if)# switchport mode trunk

Option F

 Switch1(config)# interface vlan 1 Switch1(config-if)# ip default-gateway 192.168.1.1

Correct Answer B,E
Explanation Explanation: The router will need to use subinterfaces, where each subinterface is assigned a VLAN and IP address for each VLAN. On the switch, the connection to the router need to be configured as a trunk using the switchport mode trunk command and it will need a default gateway for VLAN 1.


Question ID 13654

Refer to the exhibit.

What can be determined about the router from the console output?

Option A

No configuration file was found in NVRAM.

Option B

No configuration file was found in flash.

Option C

 No configuration file was found in the PCMCIA card.

Option D

Configuration file is normal and will load in 15 seconds.

Correct Answer A
Explanation Explanation: When no startup configuration file is found in NVRAM, the System Configuration Dialog will appear to ask if we want to enter the initial configuration dialog or not.

Send email to admin@getfreedumps for new dumps request!!!