READ Free Dumps For Cisco- 200-125

Question ID 16085	The network administrator cannot connect to Switch1 over a Telnet session, although the hosts attached to Switch1 can ping the interface Fa0/0 of the router. Given the information in the graphic and assuming that the router and Switch2 are configured properly, which of the following commands should be issued on Switch1 to correct this problem?
Option A	Switch1(config)# line con0 Switch1(config-line)# password cisco Switch1(config-line)#login
Option B	Switch1(config)# interface fa0/1 Switch1(config-if)# ip address 192.168.24.3 255.255.255.0
Option C	Switch1(config)# ip default-gateway 192.168.24.1
Option D	Switch1(config)# interface fa0/1 Switch1(config-if)# duplex full Switch1(config-if)# speed 100
Option E	Switch1(config)# interface fa0/1 Switch1(config-if)# switchport mode trunk
Correct Answer	C

Explanation Explanation: Since we know hosts can reach the router through the switch, we know that connectivity, duplex. Speed, etc. are good. However, for the switch itself to reach networks outside the local one, the ip default-gateway command must be used.

Question ID 16086	Which statement describes the process ID that is used to run OSPF on a router?
Option A	It is globally significant and is used to represent the AS number.
Option B	It is locally significant and is used to identify an instance of the OSPF database.
Option C	It is globally significant and is used to identify OSPF stub areas.
Option D	It is locally significant and must be the same throughout an area.
Correct Answer	B

Explanation Explanation: The Process ID for OSPF on a router is only locally significant and you can use the same number on each router, or each router can have a different number-it just doesn't matter. The numbers you can use are from 1 to 65,535. Don't get this confused with area numbers, which can be from 0 to 4.2 billion.

Previous-Page 1 2. . . 166 167 168 169 170 171 172. . . 181 182 Next-Page

Send email to admin@getfreedumps for new dumps request!!!