AllExam Dumps

DUMPS, FREE DUMPS, VCP5 DUMPS| VMWARE DUMPS, VCP DUMPS, VCP4 DUMPS, VCAP DUMPS, VCDX DUMPS, CISCO DUMPS, CCNA, CCNA DUMPS, CCNP DUMPS, CCIE DUMPS, ITIL, EXIN DUMPS,


READ Free Dumps For Cisco- 200-125





Question ID 16083

Refer to the exhibit.

The network administrator requires easy configuration options and minimal routing protocol
traffic. What two options provide adequate routing table information for traffic that passes
between the two routers and satisfy the requests of the network administrator? (Choose
two.)

Option A

 a dynamic routing protocol on InternetRouter to advertise all routes to CentralRouter.

Option B

a dynamic routing protocol on InternetRouter to advertise summarized routes to CentralRouter.

Option C

 a static route on InternetRouter to direct traffic that is destined for 172.16.0.0/16 to CentralRouter.

Option D

a dynamic routing protocol on CentralRouter to advertise all routes to InternetRouter.

Option E

a dynamic routing protocol on CentralRouter to advertise summarized routes to InternetRouter.

Option F

 a static, default route on CentralRouter that directs traffic to InternetRouter.

Correct Answer C,F
Explanation Explanation: The use of static routes will provide the necessary information for connectivity while producing no routing traffic overhead.


Question ID 16084

Refer to the exhibit.

A network administrator configures a new router and enters the copy startup-config
running-config command on the router. The network administrator powers down the router
and sets it up at a remote location. When the router starts, it enters the system
configuration dialog as shown. What is the cause of the problem?

Option A

The network administrator failed to save the configuration.

Option B

The configuration register is set to 0x2100.

Option C

The boot system flash command is missing from the configuration.

Option D

The configuration register is set to 0x2102.

Option E

The router is configured with the boot system startup command.

Correct Answer A
Explanation Explanation: The System Configuration Dialog appears only when no startup configuration file is found. The network administrator has made a mistake because the command copy startup-config running-config will copy the startup config (which is empty) over the running config (which is configured by the administrator). So everything configured was deleted. Note: We can tell the router to ignore the start-up configuration on the next reload by setting the register to 02142. This will make the System Configuration Dialog appear at the next reload.

Send email to admin@getfreedumps for new dumps request!!!