AllExam Dumps

DUMPS, FREE DUMPS, VCP5 DUMPS| VMWARE DUMPS, VCP DUMPS, VCP4 DUMPS, VCAP DUMPS, VCDX DUMPS, CISCO DUMPS, CCNA, CCNA DUMPS, CCNP DUMPS, CCIE DUMPS, ITIL, EXIN DUMPS,


READ Free Dumps For CISCO- 100-105





Question ID 14611

What should be part of a comprehensive network security plan?

Option A

Allow users to develop their own approach to network security.

Option B

Physically secure network equipment from potential access by unauthorized individuals.

Option C

Encourage users to use personal information in their passwords to minimize the likelihood of passwords being forgotten.

Option D

 Delay deployment of software patches and updates until their effect on end-user equipment is well known and widely reported.

Option E

 Minimize network overhead by deactivating automatic antivirus client updates.

Correct Answer B
Explanation Explanation: From Cisco CCENT Exam Essentials study guide by Todd Lammle: Know what the first part of a comprehensive network security plan is. The first part of your comprehensive network security plan is to physically secure network equipment from potential access by unauthorized individuals. List the recommended ways of protecting network devices from outside network security threats. Use a firewall to restrict access from the outside to the network devices, and use SSH or another encrypted and authenticated transport to access device configurations. Reference: CCENT Cisco Certified Entry Networking Technician Study Guide: (ICND1 Exam 640-822), 2nd Edition by Todd Lammle Published by Sybex, 2013 Topic 6, Simulation


Question ID 14612

There are three locations in a school district of a large city: ROUTER -M, ROUTER -W and
ROUTER -U. The network connection between two of these locations has already
functioned. Configure the ROUTER -M router IP addresses on the E0 and S0 interfaces so
that the E0 receives the first usable subnet while the S0 receives the second usable subnet
from the network 192.168.160.0/28. Both interfaces would receive the last available ip
address on the proper subnet.

NotE. The OSPF process must be configured to allow interfaces in specific subnets
to participate in the routing process.

Option A

Answer : ROUTER-M> enable PassworD. Cisco ROUTER-M# config t ROUTER-M(config)# interface e0 ROUTER-M(config-if)# ip address 192.168.160.14 255.255.255.240 ROUTER-M(config-if)# no shutdown ROUTER -M(config-if)# exit ROUTER -M(config)# interface s0 ROUTER-M(config-if)# ip address 192.168.160.30 255.255.255.240 ROUTER-M(config-if)# no shutdown ROUTER-M(config-if)# end ROUTER-M# copy run start

Correct Answer A
Explanation

Send email to admin@getfreedumps for new dumps request!!!