READ Free Dumps For Cisco- 300-101
Question ID 18357 | You are a network engineer with ROUTE.com, a small IT company. ROUTE.com has two
|
Option A | Answer : We need to configure policy based routing to send specific traffic along a path that is different from the best path in the routing table. R1(config)#access-list 101 permit tcp any any eq www 2) Configure the route map that sets the next hop address to be ISP1 and permits the rest R1(config)#route-map pbr permit 10 R1(config-route-map)#match ip address 101 R1(config-route-map)#set ip next-hop 10.1.100.2 R1(config-route-map)#exit R1(config)#route-map pbr permit 20 R1(config-route-map)#exit R1(config)#int fa0/1 R1(config-if)#ip policy route-map pbr R1(config-if)#exit R1(config)#exit Explanation: First you need to configure access list to HTTP traffic and then configure that access list. After that configure the route map and then apply it on the interface to the server in EIGRP network. |
Correct Answer | A |
Question ID 18358 | A packet capture log indicates that several router solicitation messages were sent from a |
Option A | Router acknowledgment messages will be forwarded upstream, where the DHCP server will allocate addresses to the local host. |
Option B | Routers on the IPv6 segment will respond with an advertisement that provides an external path from the local subnet, as well as certain data, such as prefix discovery. |
Option C | Duplicate Address Detection will determine if any other local host is using the same IPv6 address for communication with the IPv6 routers on the segment. |
Option D | All local host traffic will be redirected to the router with the lowest ICMPv6 signature, which is statically defined by the network administrator. |
Correct Answer | B |