READ Free Dumps For Cisco- 200-125
| Question ID 13605 | Refer to the exhibit.
C-router is to be used as a "router-on-a-stick" to route between the VLANs. All the
interfaces have been properly configured and IP routing is operational. The hosts in the
VLANs have been configured with the appropriate default gateway. What is true about this
configuration?
|
| Option A | These commands need to be added to the configuration: C-router(config)# router eigrp 123 C-router(config-router)# network 172.19.0.0
|
| Option B | These commands need to be added to the configuration: C-router(config)# router ospf 1 C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
|
| Option C | These commands need to be added to the configuration: C-router(config)# router rip C-router(config-router)# network 172.19.0.0
|
| Option D | No further routing configuration is required.
|
| Correct Answer | D |
Explanation Explanation: Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLA will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.
| Question ID 13606 | Refer to the exhibit.
If the router Cisco returns the given output and has not had its router ID set manually, what
value will OSPF use as its router ID?
|
| Option A | 192.168.1.1
|
| Option B | 172.16.1.1
|
| Option C | 1.1.1.1
|
| Option D | 2.2.2.2
|
| Correct Answer | D |
Explanation Explanation: If a router-id is not configured manually in the OSPF routing process the router will automatically configure a router-id determined from the highest IP address of a logical interface (loopback interface) or the highest IP address of an active interface. If more than one loopback interfaces are configured, the router will compare the IP addresses of each of the interfaces and choose the highest IP address from the loopbacks.