READ Free Dumps For Cisco- 200-125

Question ID 13555	Which two commands can be used to verify a trunk link configuration status on a given Cisco switch interface? (Choose two.)
Option A	show interface trunk
Option B	show interface interface
Option C	show ip interface brief
Option D	show interface vlan
Option E	show interface switchport
Correct Answer	A,E

Explanation Explanation: Example output from these two commands: SW3#show interface trunk Port Mode Encapsulation Status Native vlan Fa0/19 auto n-802.1q trunking 1 Fa0/20 auto n-802.1q trunking 1 Fa0/21 auto n-802.1q trunking 1 Fa0/22 auto n-802.1q trunking 1 Port Vlans allowed on trunk Fa0/19 1-4094 Fa0/20 1-4094 Fa0/21 1-4094 Fa0/22 1-4094 SW1#show interface fast 0/2 switchport Name: Fa0/2 Switchport: Enabled Administrative Mode: dynamic desirable Operational Mode: down Administrative Trunking Encapsulation: dot1q Negotiation of TrunkinG. On Access Mode VLAN: 1 (default) Trunking Native Mode VLAN: 1 (default) Voice VLAN: none

Question ID 13556	Refer to the exhibit. What set of commands was configured on interface Fa0/3 to produce the given output?
Option A	interface FastEthernet 0/3 channel-group 1 mode desirable switchport trunk encapsulation dot1q switchport mode trunk
Option B	interface FastEthernet 0/3 channel-group 2 mode passive switchport trunk encapsulation dot1q switchport mode trunk
Option C	interface FastEthernet 0/3 channel-group 2 mode active switchport trunk encapsulation dot1q switchport mode trunk
Option D	interface FastEthernet 0/3 channel-group 2 mode on switchport trunk encapsulation dot1q switchport mode trunk
Correct Answer	B

Explanation Explanation: Based on the output shown, the configured channel group number was 2 and the mode used was passive, so only choice B is correct.

Previous-Page 1 2. . . 55 56 57 58 59 60 61. . . 181 182 Next-Page

Send email to admin@getfreedumps for new dumps request!!!