READ Free Dumps For Cisco- 200-125
| Question ID 13547 | Refer to the exhibit.
Switch port FastEthernet 0/24 on ALSwitch1 will be used to create an IEEE 802.1Q-
compliant trunk to another switch. Based on the output shown, what is the reason the trunk
does not form, even though the proper cabling has been attached?
|
| Option A | VLANs have not been created yet.
|
| Option B | An IP address must be configured for the port.
|
| Option C | The port is currently configured for access mode.
|
| Option D | The correct encapsulation type has not been configured.
|
| Option E | The “no shutdown” command has not been entered for the port.
|
| Correct Answer | C |
Explanation Explanation: According to the output shown the switchport (layer 2 Switching) is enabled and the port is in access mode. To make a trunk link the port should configured as a trunk port, not an access port, by using the following command: (Config-if)#switchport mode trunk.
| Question ID 13548 | Which term describes a spanning-tree network that has all switch ports in either the
blocking or forwarding state?
|
| Option A | converged
|
| Option B | redundant
|
| Option C | provisioned
|
| Option D | spanned
|
| Correct Answer | A |
Explanation Explanation: Spanning Tree Protocol convergence (Layer 2 convergence) happens when bridges and switches have transitioned to either the forwarding or blocking state. When layer 2 is converged, root bridge is elected and all port roles (Root, Designated and Non-Designated) in all switches are selected.