READ Free Dumps For Cisco- 200-125

Question ID 16071	A Cisco router is booting and has just completed the POST process. It is now ready to find and load an IOS image. What function does the router perform next?
Option A	It checks the configuration register.
Option B	It attempts to boot from a TFTP server.
Option C	It loads the first image file in flash memory.
Option D	It inspects the configuration file in NVRAM for boot instructions.
Correct Answer	A

Explanation Explanation: Default (normal) Boot Sequence Power on Router - Router does POST - Bootstrap starts IOS load - Check configuration register to see what mode the router should boot up in (usually 0x2102 to read startup- config in NVRAM / or 0x2142 to start in "setup-mode") - check the startup-config file in NVRAM for boot-system commands - load IOS from Flash.

Question ID 16072	Refer to the exhibit. C-router is to be used as a "router-on-a-stick" to route between the VLANs. All the interfaces have been properly configured and IP routing is operational. The hosts in the VLANs have been configured with the appropriate default gateway. What is true about this configuration?
Option A	These commands need to be added to the configuration: C-router(config)# router eigrp 123 C-router(config-router)# network 172.19.0.0
Option B	These commands need to be added to the configuration: C-router(config)# router ospf 1 C-router(config-router)# network 172.19.0.0 0.0.3.255 area 0
Option C	These commands need to be added to the configuration: C-router(config)# router rip C-router(config-router)# network 172.19.0.0
Option D	No further routing configuration is required.
Correct Answer	D

Explanation Explanation: Since all the same router (C-router) is the default gateway for all three VLANs, all traffic destined to a different VLA will be sent to the C-router. The C-router will have knowledge of all three networks since they will appear as directly connected in the routing table. Since the C-router already knows how to get to all three networks, no routing protocols need to be configured.

Previous-Page 1 2. . . 159 160 161 162 163 164 165. . . 181 182 Next-Page

Send email to admin@getfreedumps for new dumps request!!!