READ Free Dumps For Cisco- 200-125

Question ID 16059	Which parameter would you tune to affect the selection of a static route as a backup, when a dynamic protocol is also being used?
Option A	hop count
Option B	administrative distance
Option C	link bandwidth
Option D	link delay
Option E	link cost
Correct Answer	B

Explanation Explanation: By default the administrative distance of a static route is 1, meaning it will be preferred over all dynamic routing protocols. If you want to have the dynamic routing protocol used and have the static route be used only as a backup, you need to increase the AD of the static route so that it is higher than the dynamic routing protocol.

Question ID 16060	Refer to the exhibit. What is the reason that the interface status is "administratively down, line protocol down"?
Option A	There is no encapsulation type configured.
Option B	There is a mismatch in encapsulation types.
Option C	The interface is not receiving any keepalives.
Option D	The interface has been configured with the shutdown command.
Option E	The interface needs to be configured as a DTE device.
Option F	The wrong type of cable is connected to the interface.
Correct Answer	D

Explanation Explanation: Interfaces can be enabled or disabled with shutdown/no shutdown command. If you interface is down, it will display administratively down status. You can bring up an interface having administratively down interface using no shutdown command.

Previous-Page 1 2. . . 153 154 155 156 157 158 159. . . 181 182 Next-Page

Send email to admin@getfreedumps for new dumps request!!!