READ Free Dumps For Cisco- 200-125

Question ID 16001	Refer to the exhibit. How should the FastEthernet0/1 ports on the switches that are shown in the exhibit be configured to allow connectivity between all devices?
Option A	The ports only need to be connected by a crossover cable.
Option B	SwitchX(config)# interface fastethernet 0/1 SwitchX(config-if)# switchport mode trunk
Option C	SwitchX(config)# interface fastethernet 0/1 SwitchX(config-if)# switchport mode access SwitchX(config-if)# switchport access vlan 1
Option D	SwitchX(config)# interface fastethernet 0/1 SwitchX(config-if)# switchport mode trunk SwitchX(config-if)# switchport trunk vlan 1 SwitchX(config-if)# switchport trunk vlan 10 SwitchX(config-if)# switchport trunk vlan 20
Correct Answer	B

Explanation Explanation: IN order for multiple VLANs to cross switches, the connection between the switches must be a trunk. The switchport mode trunk command is all that is needed, the individual VLANs should not be listed over that trunk interface.

Question ID 16002	Why will a switch never learn a broadcast address?
Option A	Broadcasts only use network layer addressing.
Option B	A broadcast frame is never forwarded by a switch.
Option C	A broadcast address will never be the source address of a frame.
Option D	Broadcast addresses use an incorrect format for the switching table.
Option E	Broadcast frames are never sent to switches.
Correct Answer	C

Explanation Explanation: Switches dynamically learn MAC addresses based on the source MAC addresses that it sees, and since a broadcast is never the source, it will never learn the broadcast address.

Previous-Page 1 2. . . 124 125 126 127 128 129 130. . . 181 182 Next-Page

Send email to admin@getfreedumps for new dumps request!!!