READ Free Dumps For CISCO- 100-105
| Question ID 14546 | R1 is configured with the default configuration of OSPF. From the following list of IP
addresses configured on R1, which address will the OSPF process select as the router ID?
|
| Option A | 192.168.0.1
|
| Option B | 172.16.1.1
|
| Option C | 172.16.2.1
|
| Option D | 172.16.2.225
|
| Correct Answer | A |
Explanation Explanation: The Router ID (RID) is an IP address used to identify the router and is chosen using the following sequencE. + The highest IP address assigned to a loopback (logical) interface. + If a loopback interface is not defined, the highest IP address of all active router's physical interfaces will be chosen. + The router ID can be manually assigned In this case, because a loopback interface is not configured so the highest active IP address 192.168.0.1 is chosen as the router ID.
| Question ID 14547 | The command ip route 192.168.100.160 255.255.255.224 192.168.10.2 was issued on a
router. No routing protocols or other static routes are configured on the router. Which
statement is true about this command?
|
| Option A | The interface with IP address 192.168.10.2 is on this router.
|
| Option B | The command sets a gateway of last resort for the router.
|
| Option C | Packets that are destined for host 192.168.100.160 will be sent to 192.168.10.2.
|
| Option D | The command creates a static route for all IP traffic with the source address 192.168.100.160.
|
| Correct Answer | C |
Explanation Explanation: With 160 it's actually network address of /27 so any address within the range of .160-.191 network will be sent to 192.168.10.2