READ Free Dumps For CISCO- 100-105

Question ID 14603	Two routers named Atlanta and Brevard are connected by their serial interfaces as shown in the exhibit, but there is no data connectivity between them. The Atlanta router is known to have a correct configuration. Given the partial configurations shown in the exhibit, what is the problem on the Brevard router that is causing the lack of connectivity?
Option A	A loopback is not set.
Option B	The IP address is incorrect.
Option C	The subnet mask is incorrect.
Option D	The serial line encapsulations are incompatible.
Option E	The maximum transmission unit (MTU) size is too large.
Option F	The bandwidth setting is incompatible with the connected interface.
Correct Answer	B

Explanation Explanation: The connection between two routers must have IP addresses that belong to the same subnet, but in this case Atlanta is using 192.168.10.1/24 and the other is in 192.168.11.1/24.

Question ID 14604	Refer to the exhibit. The network administrator is testing connectivity from the branch router to the newly installed application server. What is the most likely reason for the first ping having a success rate of only 60 percent?
Option A	The network is likely to be congested, with the result that packets are being intermittently dropped.
Option B	The branch router had to resolve the application server MAC address.
Option C	There is a short delay while NAT translates the server IP address.
Option D	A routing table lookup delayed forwarding on the first two ping packets.
Option E	The branch router LAN interface should be upgraded to FastEthernet.
Correct Answer	B

Explanation Explanation: Initially the MAC address had to be resolved, but once it is resolved and is in the ARP table of the router, pings go through immediately.

Previous-Page 1 2. . . 116 117 118 119 120 121 122. . . 142 143 Next-Page

Send email to admin@getfreedumps for new dumps request!!!