READ Free Dumps For CISCO- 100-105

Question ID 14595	Refer to the exhibit. Serial 0/0 does not respond to a ping request from a host on the FastEthernet 0/0 LAN. How can this problem be corrected?
Option A	Enable the Serial 0/0 interface.
Option B	Correct the IP address for Serial 0/0.
Option C	Correct the IP address for FastEthernet 0/0
Option D	Change the encapsulation type on Serial 0/0
Option E	Enable autoconfiguration on the Serial 0/0 interface
Correct Answer	A

Explanation Explanation: Serial 0/0 interface is administratively down therefore, you will have to run the "no shutdown" command to enable the interface for data.

Question ID 14596	What is the purpose of the switchport command? Switch(config-if)# switchport port-security maximum 1 Switch(config-if)# switchport port-security mac-address 0018.DE8B.4BF8
Option A	It ensures that only the device with the MAC address 0018.DE8B.4BF8 will be able to connect to the port that is being configured.
Option B	It informs the switch that traffic destined for MAC address 0018.DE8B.4BF8 should only be sent to the port that is being configured.
Option C	It will act like an access list and the port will filter packets that have a source or destination MAC of 0018.DE8B.4BF8.
Option D	The switch will shut down the port of any traffic with source MAC address of 0018.DE8B.4BF8.
Correct Answer	A

Explanation Explanation: The first command configurs the maximum number of secure MAC addresses on a port to one. The next command specifies that MAC addresses that are allowed with port security; in this case it is just the one single device MAC. If any other device connects on that port the port will be shut down by the port security feature.

Previous-Page 1 2. . . 112 113 114 115 116 117 118. . . 142 143 Next-Page

Send email to admin@getfreedumps for new dumps request!!!