AllExam Dumps

DUMPS, FREE DUMPS, VCP5 DUMPS| VMWARE DUMPS, VCP DUMPS, VCP4 DUMPS, VCAP DUMPS, VCDX DUMPS, CISCO DUMPS, CCNA, CCNA DUMPS, CCNP DUMPS, CCIE DUMPS, ITIL, EXIN DUMPS,


READ Free Dumps For CISCO- 100-105





Question ID 14593

Refer to the exhibit.

A technician pastes the configurations in the exhibit into the two new routers shown.
Otherwise, the routers are configured with their default configurations.
A ping from Host1 to Host 2 fails, but the technician is able to ping the S0/0 interface of R2
from Host 1. The configurations of the hosts have been verified as correct. What could be
the cause of the problem?

Option A

The serial cable on R1 needs to be replaced.

Option B

The interfaces on R2 are not configured properly

Option C

 R1 has no route to the 192.168.1.128 network.

Option D

The IP addressing scheme has overlapping subnetworks.

Option E

The ip subnet-zero command must be configured on both routers.

Correct Answer C
Explanation Explanation: Without a static route pointing to the host 2 network the router R1 is unaware of the path to take to reach that network and reply traffic cannot be sent.


Question ID 14594

Refer to the exhibit.

After the power-on-self test (POST), the system LED of a Cisco 2950 switch turns amber.
What is the status of the switch?

Option A

The POST was successful.

Option B

The switch has a problem with the internal power supply and needs an external power supply to be attached.

Option C

POST failed and there is a problem that prevents the operating system from being loaded.

Option D

 The switch has experienced an internal problem but data can still be forwarded at a slower rate.

Option E

The switch passed POST, but all the switch ports are busy.

Correct Answer C
Explanation Explanation: http://www.cisco.com/en/US/products/hw/switches/ps607/products_tech_note09186a00801 25913.shtml Each time you power up the switch, eight Power-On Self Tests (POSTs) run automatically. POSTs check the most important system components before the switch begins to forward packets. When the switch begins the POST, the port status LEDs display amber for two seconds, and then display green. As each test runs, the port status LEDs go out. 1x is the first to go out. The port status LEDs for ports 2x through 8x go out sequentially as the system completes a test. When the POST completes successfully, the port status LEDs go out. This indicates that the switch is operational. If a test fails, the port status LED associated with the test displays amber. The system LED also displays amber. Not E: From Cisco IOS Software Release 11.2(8.5) SA6 onwards, the port and system LEDs both remain amber after a POST failure. In the earlier Cisco IOS Software Releases, only the LEDs of failed linked ports remained amber.

Send email to admin@getfreedumps for new dumps request!!!