READ Free Dumps For VMware- VCP5-DCV

Question ID 5386	-- Exhibit --   -- Exhibit -- A vSphere administrator assigns VLAN 3389 to the Production port group on the VCP_DCV_Example vSphere Distributed Switch. After the change, users report a loss of connectivity to their applications. Further analysis provides the following data: •    The cluster has not had a ESXi host failure. •    Application functioned normally prior to the change. •    The loss of connectivity occurred immediately following the change. Which condition would cause this loss of connectivity?
Option A	A.    The physical switch ports used by the vmnics have not been configured with 802.1Q.
Option B	B.    Maintenance Mode was initiated on one of the hosts in the cluster. Connectivity will resume after the virtual machines are migrated.
Option C	C.    All uplinks were removed from the VCP_DCV_Example switch and added to another virtual switch.
Option D	D.    A load balancing setting on the port group conflicts with the load balancing setting of the switch.
Correct Answer	A

Explanation

Question ID 5387	Why would an administrator be unable to locate an IP address for a vSphere vmnic uplink?
Option A	A.    IP addresses are defined at the virtual nic level, not the vmnic level.
Option B	B.    ESXi host vmnics communicate with physical switches on layer 3.
Option C	C.    ESXi hosts use NAT translation to mask the actual vmnic IP address.
Option D	D. The IP address of the vmnic is not shown in the vSphere Client.
Correct Answer	A

Explanation

Previous-Page 1 2. . . 200 201 202 203 204 205 206. . . 285 286 Next-Page

Send email to admin@getfreedumps for new dumps request!!!