READ Free Dumps For Cisco- 642-732
| Question ID 19141 | You have been contacted by a medium sized medical center to do a site survey of their |
| Option A | The additional voice endpoints may increase additional load, which may increase delay in the WLAN and cause voice quality to degrade. |
| Option B | There will not be any issues due to adding the Vocera voice badges because they are point-to-point devices and do not require the infrastructure to communicate. |
| Option C | Verify the WLAN is multicast enabled for Vocera voice badges. |
| Option D | To make these devices as efficient as possible, the Vocera voice badges should be placed on their own unicast SSID/VLAN. |
| Option E | Verify the WLAN that is being used by the Vocera voice badges is configured in the WLC to use the Gold QoS value. |
| Correct Answer | A,C |
| Question ID 19142 | After you have run the VoWLAN Voice Readiness Tool in WCS 7.0, you see there are |
| Option A | Verify the green, yellow, and red regions in the RF environment only if the floor has not been calibrated. |
| Option B | To prevent one-way audio, set the AP power levels to half the power of the client. This will ensure proper radio coverage. |
| Option C | You need to edit the RSSI values for Cisco IP Phones so the 802.11b/g/n radios display the region map properly. |
| Option D | Determine if the coverage area will have enough APs to support the VoWLAN client, since all APs must have a Tx power level that does not exceed that of the client. |
| Option E | Set the AP power level to match the VoWLAN client to avoid one-way audio. |
| Correct Answer | D,E |