READ Free Dumps For Cisco- 400-101

Question ID 18600	Refer to the exhibit. All switches are Cisco switches. Assume that Cisco Discovery Protocol is enabled only on switches A and C. Which information is returned when you issue the command show cdp neighbors on switchC?
Option A	a limited amount of information about switch B
Option B	no neighbor details will be returned
Option C	neighbor details for switch B
Option D	neighbor details for switch A
Option E	neighbor details for switch C
Correct Answer	B

Explanation Explanation: CDP is used to discover information on directly connected neighbors only, so in this case SwitchC would only be able to obtain CDP information from SwitchB. However, since SwitchB is not running CDP then no neighbor information will be seen on SwitchC. Same goes for Switch A also in this topology.

Question ID 18601	Which three modes are valid for forming an EtherChannel between the ports of two switches? (Choose three.)
Option A	Active/active
Option B	Active/passive
Option C	Passive/passive
Option D	Auto/auto
Option E	Auto/desirable
Option F	Answer : A,B,E Explanation: To configure an EtherChannel using LACP negotiation, each side must be set to either active or passive; only interfaces configured in active mode will attempt to negotiate an EtherChannel. Passive interfaces merely respond to LACP requests. PAgP behaves the same, but its two modes are refered to as desirable and auto. Reference: http://packetlife.net/blog/2010/jan/18/etherchannel-considerations/
Correct Answer	F

Explanation

Previous-Page 1 2... 57 58 59 60 61 62 63 64 65 Next-Page

Send email to admin@getfreedumps for new dumps request!!!