READ Free Dumps For Cisco- 300-135
| Question ID 13485 | The implementations group has been using the test bed to do a proof-of-concept.
After several changes to the network addressing, routing schemes, a trouble ticket
has been opened indicating that the loopback address on R1 (2026::111:1) is not
able to ping the loopback address on DSW2(2026::102:1).
Use the supported commands to isolated the cause of this fault and answer the
following questions.
On which device is the fault condition located?
|
| Option A | R1
|
| Option B | R2
|
| Option C | R3
|
| Option D | R4
|
| Option E | DSW1
|
| Option F | DSW2
|
| Correct Answer | B |
Explanation Explanation: R2 is missing the needed IPV6 OSPF for interface s0/0/0.23
| Question ID 13486 | The implementations group has been using the test bed to do a proof-of-concept.
After several changes to the network addressing, routing schemes, a trouble ticket
has been opened indicating that the loopback address on R1 (2026::111:1) is not
able to ping the loopback address on DSW2(2026::102:1).
Use the supported commands to isolated the cause of this fault and answer the
following questions.
What is the solution to fault condition?
|
| Option A | Under the interface Serial 0/0/0.23 configuration enter the ipv6 ospf 6 area 0 command.
|
| Option B | Under the interface Serial0/0/0.12 configuration enter the ipv6 ospf 6 area 12 command.
|
| Option C | Under ipv6 router ospf 6 configuration enter the network 2026::1:/122 area 0 command.
|
| Option D | Under ipv6 router ospf 6 configuration enter no passive-interface default command.
|
| Correct Answer | A |
Explanation Explanation: On R2, IPV6 OSPF routing, configuration is required to add ipv6 ospf 6 area 0 under interface serial 0/0/0.23