AllExam Dumps

DUMPS, FREE DUMPS, VCP5 DUMPS| VMWARE DUMPS, VCP DUMPS, VCP4 DUMPS, VCAP DUMPS, VCDX DUMPS, CISCO DUMPS, CCNA, CCNA DUMPS, CCNP DUMPS, CCIE DUMPS, ITIL, EXIN DUMPS,


READ Free Dumps For Cisco- 300-135





Question ID 13440

When troubleshooting an EIGRP connectivity problem, you notice that two connected
EIGRP routers are not becoming EIGRP neighbors. A ping between the two routers was
successful. What is the next thing that should be checked?

Option A

Verify that the EIGRP hello and hold timers match exactly.

Option B

Verify that EIGRP broadcast packets are not being dropped between the two routers
with the show ip EIGRP peer command.

Option C

Verify that EIGRP broadcast packets are not being dropped between the two routers
with the show ip EIGRP traffic command.

Option D

Verify that EIGRP is enabled for the appropriate networks on the local and neighboring
router.

Correct Answer D
Explanation Topic 2, Troubleshooting VTP


Question ID 13441

A customer network engineer has made configuration changes that have resulted in some
loss of connectivity. You have been called in to evaluate a switch network and suggest
resolutions to the problems.

PC2 in VLAN 200 is unable to ping the gateway address 172.16.200.1; identify the issue.

Option A

VTP domain name mismatch on SW4

Option B

 VLAN 200 not configured on SW1

Option C

 VLAN 200 not configured on SW2 

Option D

VLAN 200 not configured on SW4

Option F

Answer : C

Explanation: By looking at the configuration for SW2, we see that it is missing VLAN 200, and the switchport access vlan 200 command is missing under interface eth 0/0:

Correct Answer C
Explanation

Send email to admin@getfreedumps for new dumps request!!!