READ Free Dumps For Cisco- 300-135

Question ID 13432	Refer to the shown below. %LINK-3-UPDOWN: Interface Serial0/0, changed state to up %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0/0, changed state to up What statement is correct regarding the output shown in the graphic?
Option A	These two log messages will not have a severity level. They are not errors but are just informational messages.
Option B	The first log message is categorized as a warning message.
Option C	These messages regarding interface status are normal output and will always be displayed when you exit config mode.
Option D	The first log message is an error message with a severity level of 3.
Option E	The second message would be shown if the logging console warning command had been issued.
Correct Answer	D

Explanation

Question ID 13433	Refer to the configuration statements shown in the graphic above. R1(config)#access-list 199 permit tcp host 10.1.1.1 host 172.16.1.1 R1(config)#access-list 199 permit tcp host 172.16.1.1 host 10.1.1.1 R1(config)#end R1#debug ip packet 199 detail Which statement reflects what the effect is of this configuration sequence?
Option A	These commands will generate an error message because you cannot use an access list with any debug commands.
Option B	These commands will have no effect at all. The debug ip packet command will work as normal and display info for all IP packets.
Option C	These commands turn on debug ip packet only for packets between hosts 10.1.1.1 and 172.16.1.1.
Option D	These commands will only work when you specify only one host rather than two.
Correct Answer	C

Explanation

Previous-Page 1 2. . . 7 8 9 10 11 12 13. . . 80 81 Next-Page

Send email to admin@getfreedumps for new dumps request!!!