READ Free Dumps For Cisco- 300-115

Question ID 15783	A network engineer must set the load balance method on an existing port channel. Which action must be done to apply a new load balancing method?
Option A	Configure the new load balancing method using port-channel load-balance.
Option B	Adjust the switch SDM back to "default".
Option C	Ensure that IP CEF is enabled globally to support all load balancing methods.
Option D	Upgrade the PFC to support the latest load balancing methods.
Correct Answer	A

Explanation

Question ID 15784	Refer to the exhibit. An engineer is configuring EtherChannel between two switches and notices the console message on switch 2. Based on the output, which option describes the reason for this error?
Option A	Switch 1 does not have enough member ports configured.
Option B	Switch 2 has too many member ports configured.
Option C	The port channel interface numbers do not match.
Option D	The EtherChannel protocols do not match.
Correct Answer	D

Explanation

Previous-Page 1 2. . . 32 33 34 35 36 37 38. . . 74 75 Next-Page

Send email to admin@getfreedumps for new dumps request!!!