AllExam Dumps

DUMPS, FREE DUMPS, VCP5 DUMPS| VMWARE DUMPS, VCP DUMPS, VCP4 DUMPS, VCAP DUMPS, VCDX DUMPS, CISCO DUMPS, CCNA, CCNA DUMPS, CCNP DUMPS, CCIE DUMPS, ITIL, EXIN DUMPS,


READ Free Dumps For Cisco- 300-115





Question ID 15747

SWITCH.com is an IT company that has an existing enterprise network comprised of two
layer 2 only switches; DSW1 and ASW1. The topology diagram indicates their layer 2
mapping. VLAN 20 is a new VLAN that will be used to provide the shipping personnel
access to the server. Corporate polices do not allow layer 3 functionality to be enabled on
the switches. For security reasons, it is necessary to restrict access to VLAN 20 in the
following manner:
Users connecting to VLAN 20 via portfO/1 on ASW1 must be authenticated before they
are given access to the network. Authentication is to be done via a Radius server:
Radius server host: 172.120.40.46
Radius key: rad123
Authentication should be implemented as close to the host as possible.
Devices on VLAN 20 are restricted to the subnet of 172.120.40.0/24.
Packets from devices in the subnet of 172.120.40.0/24 should be allowed on VLAN 20.
Packets from devices in any other address range should be dropped on VLAN 20.
Filtering should be implemented as close to the serverfarm as possible.
The Radius server and application servers will be installed at a future date. You have been
tasked with implementing the above access control as a pre-condition to installing the
servers. You must use the available IOS switch features.

Option A

Answer : Console to ASW1 from PC console 1 ASW1(config)#aaa new-model ASW1(config)#radius-server host 172.120.39.46 key rad123 ASW1(config)#aaa authentication dot1x default group radius ASW1(config)#dot1x system-auth-control ASW1(config)#inter fastEthernet 0/1 ASW1(config-if)#switchport mode access ASW1(config-if)#dot1x port-control auto ASW1(config-if)#exit ASW1#copy run start Console to DSW1 from PC console 2 DSW1(config)#ip access-list standard 10 DSW1(config-ext-nacl)#permit 172.120.40.0 0.0.0.255 DSW1(config-ext-nacl)#exit DSW1(config)#vlan access-map PASS 10 DSW1(config-access-map)#match ip address 10 DSW1(config-access-map)#action forward DSW1(config-access-map)#exit DSW1(config)#vlan access-map PASS 20 DSW1(config-access-map)#action drop DSW1(config-access-map)#exit DSW1(config)#vlan filter PASS vlan-list 20 DSW1#copy run start

Correct Answer A
Explanation


Question ID 15748

Your customer has asked you to come in and verify the operation of routers R1 and R2
which are configured to use HSRP. They have questions about how these two devices will
perform in the event of a device failure.

What percentage of the outgoing traffic from the 172.16.10.0/24 subnet is being forwarded
through R1?

Option A

R1-0%

Option B

R1-50 %, R2-50%

Option C

R2-100%

Option D

 R1-100%

Correct Answer D
Explanation

Send email to admin@getfreedumps for new dumps request!!!