READ Free Dumps For Cisco- 300-101

Question ID 18395	Router RTA is configured as follows: RTA (config)#router rip RTA(config-router)#network 10.0.0.0 RTA(config-router)#distribute-list 44 in interface BRIO RTA(config-router)#exit RTA(config)#access-list 44 deny 172.16.1.0 0.0.0.255 RTA(config)#access-list 44 permit any What are the effects of this RIP configuration on router RTA? (Choose two)
Option A	no routing updates will be sent from router RTA on interface BRIO to router RTX
Option B	router RTA will not advertise the 10.0.0.0 network to router RTX
Option C	the route to network 172.16.1.0 will not be entered into the routing table on router RTA
Option D	user traffic from the 172.16.1.0 network is denied by access-list 44
Option E	the routing table on router RTA will be updated with the route to router RTW
Correct Answer	C,E

Explanation Explanation: Distribute list are used to filter routing updates and they are based on access lists. In this case, an access list of 44 was created to deny the route from network 172.16.1.0/24 so this route will not be entered into the routing table of RTA. But the route from RTW can be entered because it is not filtered by the access list A and B are not correct because the distribute list is applied to the inbound direction of interface BRI0 so outgoing routing updated will not be filtered. Distribute list just filters routing updates so user traffic from network 172.16.1.0 will not be denied.

Question ID 18396	For troubleshooting purposes, which method can you use in combination with the “debug ip packet” command to limit the amount of output data?
Option A	You can disable the IP route cache globally.
Option B	You can use the KRON scheduler.
Option C	You can use an extended access list.
Option D	You can use an IOS parser.
Option E	You can use the RITE traffic exporter.
Correct Answer	C

Explanation

Previous-Page 1 2. . . 72 73 74 75 76 77 78. . . 117 118 Next-Page

Send email to admin@getfreedumps for new dumps request!!!