AllExam Dumps

DUMPS, FREE DUMPS, VCP5 DUMPS| VMWARE DUMPS, VCP DUMPS, VCP4 DUMPS, VCAP DUMPS, VCDX DUMPS, CISCO DUMPS, CCNA, CCNA DUMPS, CCNP DUMPS, CCIE DUMPS, ITIL, EXIN DUMPS,


READ Free Dumps For Cisco- 300-101





Question ID 7697

A network engineer is asked to configure a "site-to-site" IPsec VPN tunnel. One of the last things that the engineer does is to configure an access list (access-list 1 permit any) along with the command ip nat inside source list 1 int s0/0 overload. Which functions do the two commands serve in this scenario?

Option A

The command access-list 1 defines interesting traffic that is allowed through the tunnel.

Option B

The command ip nat inside source list 1 int s0/0 overload disables "many-to-one" access for all devices on a defined segment to share a single IP address upon exiting the external interface.

Option C

The command access-list 1 permit any defines only one machine that is allowed through the tunnel.

Option D

The command ip nat inside source list 1 int s0/0 overload provides "many-to-one" access for all devices on a defined segment to share a single IP address upon exiting the external interface.

Correct Answer D
Explanation


Question ID 7698

A network engineer is configuring a solution to allow failover of HSRP nodes during maintenance windows, as an alternative to powering down the active router and letting the network respond accordingly. Which action will allow for manual switching of HSRP nodes?

Option A

Track the up/down state of a loopback interface and shut down this interface during maintenance.

Option B

Adjust the HSRP priority without the use of preemption.

Option C

Disable and enable all active interfaces on the active HSRP node.

Option D

Enable HSRPv2 under global configuration, which allows for maintenance mode.

Correct Answer A
Explanation

Send email to admin@getfreedumps for new dumps request!!!