READ Free Dumps For Cisco- 200-120
| Question ID 626 | Refer to the exhibit.
How should the FastEthernet0/1 ports on the 2950 model switches that are shown in the exhibit be configured to allow connectivity between all devices? |
| Option A | The ports only need to be connected by a crossover cable. |
| Option B | SwitchX(config)# interface fastethernet 0/1 SwitchX(config-if)# switchport mode trunk |
| Option C | SwitchX(config)# interface fastethernet 0/1 SwitchX(config-if)# switchport mode access SwitchX(config-if)# switchport access vlan 1 |
| Option D | SwitchX(config)# interface fastethernet 0/1 SwitchX(config-if)# switchport mode trunk SwitchX(config-if)# switchport trunk vlan 1 SwitchX(config-if)# switchport trunk vlan 10 SwitchX(config-if)# switchport trunk vlan 20 |
| Correct Answer | B |
| Question ID 627 | Refer to the exhibit.
A frame on VLAN 1 on switch S1 is sent to switch S2 where the frame is received on VLAN 2. What causes this behavior? |
| Option A | trunk mode mismatches |
| Option B | allowing only VLAN 2 on the destination |
| Option C | native VLAN mismatches |
| Option D | VLANs that do not correspond to a unique IP subnet |
| Correct Answer | C |
