READ Free Dumps For CISCO- 100-105
| Question ID 14437 | A network administrator is connecting PC hosts A and B directly through their Ethernet
interfaces as shown in the graphic. Ping attempts between the hosts are unsuccessful.
What can be done to provide connectivity between the hosts? (Choose two.)
|
| Option A | A crossover cable should be used in place of the straight-through cable.
|
| Option B | A rollover cable should be used in place of the straight-through cable.
|
| Option C | The subnet masks should be set to 255.255.255.192
|
| Option D | A default gateway needs to be set on each host.
|
| Option E | The hosts must be reconfigured to use private IP addresses for direct connections of this type.
|
| Option F | The subnet masks should be set to 255.255.255.0
|
| Correct Answer | A,F |
Explanation Explanation: If you need to connect two computers but you don't have access to a network and can't set up an ad hoc network, you can use an Ethernet crossover cable to create a direct cable connection. Generally speaking, a crossover cable is constructed by reversing (or crossing over) the order of the wires inside so that it can connect two computers directly. A crossover cable looks almost exactly like a regular Ethernet cable (a straight-through cable), so make sure you have a crossover cable before following these steps. Both devices need to be on the same subnet, and since one PC is using 192.1.1.20 and the other is using 192.1.1.201, the subnet mask should be changed to 255.255.255.0.
| Question ID 14438 | Refer to the exhibit.
A network device needs to be installed in the place of the icon labeled Network Device to
accommodate a leased line attachment to the Internet. Which network device and interface
configuration meets the minimum requirements for this installation?
|
| Option A | a router with two Ethernet interfaces
|
| Option B | a switch with two Ethernet interfaces
|
| Option C | a router with one Ethernet and one serial interface
|
| Option D | a switch with one Ethernet and one serial interface
|
| Option E | a router with one Ethernet and one modem interface
|
| Correct Answer | C |
Explanation Explanation: Only a router can terminate a leased line attachment access circuit, and only a router can connect two different IP networks. Here, we will need a router with two interfaces, one serial connection for the line attachment and one Ethernet interface to connect to the switch on the LAN.