AllExam Dumps

DUMPS, FREE DUMPS, VCP5 DUMPS| VMWARE DUMPS, VCP DUMPS, VCP4 DUMPS, VCAP DUMPS, VCDX DUMPS, CISCO DUMPS, CCNA, CCNA DUMPS, CCNP DUMPS, CCIE DUMPS, ITIL, EXIN DUMPS,


READ Free Dumps For Cisco- 100-101





Question ID 6401

Which two of these functions do routers perform on packets? (Choose two.)

Option A

A. Examine the Layer 2 headers of inbound packets and use that information to determine the next hops for the packets

Option B

. Update the Layer 2 headers of outbound packets with the MAC addresses of the next hops

Option C

Examine the Layer 3 headers of inbound packets and use that information to determine the next hops for the packets

Option D

. Examine the Layer 3 headers of inbound packets and use that information to determine the complete paths along which the packets will be routed to their ultimate destinations

Option E

. Update the Layer 3 headers of outbound packets so that the packets are properly directed to valid next hops

Option F

Update the Layer 3 headers of outbound packets so that the packets are properly directed to their ultimate destinations

Correct Answer bc
Explanation This is the basic function of the router to receive incoming packets and then forward them to their required destination. This is done by reading layer 3 headers of inbound packets and update the info to layer 2 for further hopping.


Question ID 6402

Which two commands will display the current IP address and basic Layer 1 and 2 status of an interface? (Choose two.)

Option A

router#show version

Option B

router#show ip interface

Option C

router#show protocols

Option D

router#show controllers

Option E

 router#show running-config

Correct Answer bc
Explanation The outputs of “show protocols” and “show ip interface” are shown below

Send email to admin@getfreedumps for new dumps request!!!