READ Free Dumps For Cisco- 200-125

Question ID 16087	Which command reveals the last method used to powercycle a router?
Option A	show reload
Option B	show boot
Option C	show running-config
Option D	show version
Option F	Answer : D Explanation: The show version command can be used to show the last method to powercycle (reset) a router.
Correct Answer	F

Explanation

Question ID 16088	Refer to the graphic. R1 is unable to establish an OSPF neighbor relationship with R3. What are possible reasons for this problem? (Choose two.)
Option A	All of the routers need to be configured for backbone Area 1.
Option B	R1 and R2 are the DR and BDR, so OSPF will not establish neighbor adjacency with R3.
Option C	A static route has been configured from R1 to R3 and prevents the neighbor adjacency from being established.
Option D	The hello and dead interval timers are not set to the same values on R1 and R3.
Option E	EIGRP is also configured on these routers with a lower administrative distance.
Option F	R1 and R3 are configured in different areas.
Correct Answer	D,F

Explanation Explanation: This question is to examine the conditions for OSPF to create neighborhood. So as to make the two routers become neighbors, each router must be matched with the following items: 1. The area ID and its types; 2. Hello and failure time interval timer; 3. OSPF Password (Optional).

Previous-Page 1 2. . . 167 168 169 170 171 172 173. . . 181 182 Next-Page

Send email to admin@getfreedumps for new dumps request!!!